Proxxon 37006 Use and Care Manual download pdf (Page 10)

- 8 -

Before start-up:

Replacing the saw blade

Important

Before changing the saw blade, pull out the mains

plug.

1. Open the sliding door 2 (Fig.3) with the hexagon key.

2. Introduce 2 mm hexagon key 1 into the work desk

block and the drive shaft.

3. Using the 3 mm hexagon keys 5 (Fig. 4) unscrew

screw 4, remove ring 3 and saw blade 2.

4. Place the new saw blade on the sawing shaft 1,

replace ring 3, screw in screw 4 and tighten.

Note:

The choice of the saw blade will depend on the

material to be sawed.

Respect the direction of rotation as shown on the

Proxxon-Saw blades.

Connecting the vacuum cleaner

For longer periods of operation, we recommend

connecting the saw to a vacuum cleaner. To this end,

connect the vacuum cleaner at the connection tube 10

(Fig. 1) using the attached rubber adapter.

Working with the circular saw

Warning!

For your own safety, do not plug the tool into the

power source receptacle, until the parts are correctly

installed and adjustments have been made.

Warning:

Secure and exact work is only possible if the machine

is properly fastened!

Important

When working with the circular saw, please observe

the following additional safety notes.

1. When working directly on the saw blade, use the

sliding stick.

2. Never work without the splitting cotter or without the

saw blade cover .

3. In case of wear at the sawing gap, replace the entire

table top.

4. Only work on work pieces, for which the desk size

provides a safe base, so that tilting of the work piece

is prevented.

5. Only use faultless saw blades.

6. Replace blunt of saw blades in good time.

7. Do not leave the device unsupervised.

Note:

This is a circular saw for fine work! Work with moderate

rate of feed and pay attention to the speed drop of the

saw blade!

Sawing with the longitudinal stop

Release the clamping screw 1 (Fig. 5), set stop and

again retighten the clamping screw (the max. work

piece width amounts to 70 mm).

Sawing with the angle stop

Release the clamping screw 1 (Fig. 6), set the angles

according to the scale and retighten the clamping

screw. Then push the work piece lightly against the

stop and guide the stop along groove 2.

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Proxxon 37006 Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Proxxon 37006