- 9 -
Operation
Warning!
To avoid injury from accidental start, make sure the
switch is in the OFF position and the plug is not
connected to the power source receptacle before
changing any parts or drills.
Important!
Safe and precision working practice can only be
ensured with the unit properly secured!
Do not leave the unit switched on if unsupervised.
Before operation:
First fasten the machine securely on a strong base.
Warning !
To avoid injury from unexpected starting or electrical
shock, do not plug the power cord into a power source
receptacle during unpacking and assembly. This cord
must remain unplugged whenever you are working on
the drill press .
Clamping, changing the tool
Warning !
For your safety, never connect the plug to the power
source receptacle until the assembly and adjustment
steps are completed, and you have read and
understood the safety and operating instructions.
Tightening the spigot nut without inserting a suitable
shank will damage the collet.
1. Insert the pin 4 (Fig. 2) into the bore and block the
spindle.
2. Unscrew the spigot nut (2).
3. Insert the required collet (3) with the appropriate tool
(1) and retighten the spigot nut.
Note:
Clamp all tools as short as possible. Extremely
protruding shanks will bend and cause eccentric
rotation.
Clamping, changing tools with the optional drill
chuck
(not included)
Attention!
Pull the mains plug out when changing tools.
Warning!
For your own safety, do not plug the tool into the power
source receptacle or insert the switch key, until the
parts are correctly installed and adjustments have been
made.
• Insert the drill chuck key 2 (Fig. 3) into the drill
chuck (1).
• Turn the drill chuck key in direction "A” to open the
drill chuck.
• Insert the tool into the drill chuck until it bottoms.
• Turn the drill chuck key in direction "B” to close the
drill chuck and to clamp the tool.
Removing and installing the drill chuck
Note:
This must be done to install the steel collets.
Attention!
Pull the mains plug out beforehand.
1. Insert the pin 3 ( Fig. 4) into the bore and block the
spindle.
2. Insert the drill chuck key (1) and unscrew or tighten
the drill chuck. (2).
Adjusting the spindle speed
Attention!
Pull the mains plug out beforehand.
Do not use the machine without protective covering.
Note:
High performance is not achieved by high feeding
speed, but correct and uniform rotary speed.
Belt position "A” = 1.800 rpm
Belt position "B” = 4.700 rpm
Belt position "C” = 8.500 rpm
small drill Ø = high speed
big drill Ø = low speed.
1. Unscrew the knurled screw 1 (Fig. 5) and lift the
cover (2) off.
Attention!
Work careful to avoid damage to the belt.
2. Turn the belt pulley 1 (Fig. 6) in direction "A” and
press the belt slightly down (or up) until it comes
loose.
3. Place the loose belt first on the required pulley (1)
then turn the spindle and force the belt on the
corresponding disc on the motor spindle.
4. Reinstall the cover.
(8 pages)
(38 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals